EN
- Overview
- Related Products
1. Product Composition
Component |
Material & Spec |
Details |
Tap Body & Spring Outer Shell |
Food-grade 304 Stainless Steel |
Brushed anti-fingerprint finish, rust-proof |
Inner Pull Hose |
Nylon Flexible Hose |
Wear-resistant, stretchable retractable line |
Inlet Supply Hoses |
High-pressure Resistant Braided Hoses |
Burst-proof for cold & hot water supply |
Control Cartridge |
Single lever hot/cold mix ceramic cartridge |
Stable temperature & flow regulation |
Spray Head |
304 Stainless Steel with switch button |
Dual water modes: Stream / Spray |
Support Cross Bar |
304 Stainless Steel |
Reinforces structural stability |
Sealing Parts |
Food-grade silicone gaskets & O-rings |
Full leak-proof sealing for all joints |
2. Colors available:
Chrome, Brushed nickel, Gun mental, Matt black, Brushed brass, Golden,
3. Operation Guide
3.1 Water On & Temperature Adjustment
Lift the right lever upward to turn water on; higher lift = stronger water flow.
Tilt lever left for colder water, tilt right for hotter water; middle position delivers warm mixed water.
3.2 Dual Spray Head Switch
Press the side button on the spray head to swap:
Stream Mode: Concentrated soft column water
Spray Mode: Wide powerful shower water
3.2 Turn Off
Push the lever fully down to cut off all water flow. Release spray head, the spring and nylon hose pull it back into place automatically.
4. Key Features
4.1 Full 304 stainless steel construction (body + spring housing), brushed matte surface resists fingerprints, rust and kitchen corrosion.
4.2 Flexible spring pull-down design, ultra-wide cleaning range for large pots and double sinks.
4.3 Two-function spray head meets diverse washing demands; one-click mode switch.
4.4 Durable nylon retractable hose, flexible and not easy to crack after frequent pulling.
4.5 High-pressure burst-proof braided inlet hoses, adapts to most household water pressure.
4.6 Standard single-hole deck mount, easy to fit most kitchen sinks.
5. Product Applications
5.1 Household kitchen: Washing fruit, vegetables, tableware, large cookware, deep sink cleaning
5.2 Light commercial: Café prep areas, office pantries, homestay kitchens
6. Installation Notes
6.1 Close main cold/hot water valves and drain residual pipeline water before assembly.
6.2 Connect high-pressure braided hoses to tap inlet ports; tighten nuts moderately to avoid thread breakage and leakage.
6.3 Thread the nylon pull hose through the spring shell carefully, prevent sharp twisting or pinching.
6.4 Mount rubber gasket between tap base and sink surface, fasten bottom lock nut firmly to stop wobble.
6.5 Post-install test: Turn on water slowly, check all joints for leaks; test lever adjustment, spray mode switch and automatic retraction performance.
7. Usage Instructions
7.1 Pull the spray head gently, do not yank the nylon hose violently to avoid internal line damage.
7.2 Toggle the spray head button lightly; do not apply excessive force to the switch tab.
7.3 Avoid long-time continuous maximum hot water output to extend nylon hose service life.
7.4 Always let the spray head retract fully after use to reduce hose fatigue.
8. Troubleshooting
Fault |
Cause |
Solution |
Weak water flow |
Supply valve not fully open, hose kinked, spray head mesh clogged |
Open valves fully, straighten hoses, rinse spray head filter |
Tap drips after closing lever |
Worn mixing ceramic cartridge, damaged inner silicone seals |
Replace matching original cartridge or sealing rings |
Spray head fails to retract |
Nylon hose tangled inside spring shell |
Untangle and straighten the internal pull hose |
Leakage at tap base |
Missing/aged base rubber gasket, loose fixing nut |
Fit new intact gasket, evenly tighten base lock nut |
Cannot switch spray modes smoothly |
Limescale stuck inside spray head mechanism |
Soak spray head in mild neutral descaler, rinse thoroughly |
9. Maintenance & Care
9.1 Daily cleaning: Wipe stainless steel surface with soft cloth and mild neutral cleaner. Never use steel wool or acid cleaners which scratch the brushed finish.
9.2 Long-term idle: Shut off main water supply, drain all residual water inside tap and hoses to prevent freeze cracking or stagnant water odour.
10. Suitable User Groups
10.1 Modern minimalist style home owners, stainless steel fixture preference buyers
10.2 Families with large cookware or double-basin kitchen sinks
10.3 Rental property renovators, budget-friendly durable fixture seekers
10.4 Users wanting wide flexible pull-down cleaning coverage
11. FAQ
Q1: Is the tap body made of stainless steel or brass?
A1: Main body and spring outer shell are 304 food-grade stainless steel. Q2: How many water modes does the spray head have?
A2: Two modes: steady stream and powerful spray, switched by one side button.
Q3: What material is the inner retractable pull hose?
A3: Wear-resistant flexible nylon hose with good stretch recovery.
Q4: Are the inlet connecting hoses pressure-resistant?
A4: Yes, equipped with high-pressure burst-proof braided water supply hoses.
Q5: Can I replace the nylon pull hose myself if it wears out?
A5: Yes, standard size compatible replacement nylon hoses can be installed with simple DIY steps.
